Carburetor polishing was such a pain that I decided to get the EZ-BLUST.
I only use it dry (though I do have the wet option). There’s one problem though.
The blast on/off switch is on top of the unit.
Since I was planning to use it inside a box, that’s a real hassle—seriously annoying.
So I converted it to a foot switch using a solenoid valve.
Direct-acting 2-port solenoid valve (Multiplex valve) NC (open when energized) type AB31/AB41 series, rated voltage AC100V, connection port diameter (Rc) 1/4, AB31-02-3-AC100V
Foot switch S3 &M3 series [for small equipment], contact configuration 1a, rating 6A-250VAC, front hinge type, OFL-V-S3
Hex nipple, stainless steel threaded fitting 1/4B, 8A, 6N
I used it for installation.
I haven’t used it yet so I can’t say for sure, but it should be convenient.
Before buying, I first got the media and tested it, and this media is excellent!
I’ll let you know more about that when I get a chance.
