Everyone says so, but
this GSF isn’t mine.
Well…
I’ll wash the calipers with hot water and soap.
Wash thoroughly ⇒ wipe dry ⇒ push out the piston ⇒ apply metal rubber ⇒ massage ⇒ push out ⇒ massage ⇒ push out
After all that massaging, it finally started moving smoothly again.
The movement was really bad.
Since it’s a racing caliper, let’s wash it occasionally.
Fluid replaced and pins polished ★ All set
I tested it by putting a rolling test piece in the caliper, so I’d like to test it.
The carburetors are out of sync too.
The air cleaner is a bit dirty.
This should make it run really great.
Woohoo
