The inspection was done on 5/20 . . .
Sorry for the delay★ Getting started . . .
There’s a lot of that kind of thing on the left side, and I apologize.
Just looking . . .
Want to put a cover on it
Fed up with the wiring
Somehow
Connectors coming loose & mismatched terminals
①and so on ②and so on
Solder joints too . . . way too many terminals . . . octopus-style mess
Removing this
I thought about laying it out under the tank
But it would need quite a bit of extension overall, so I’m going with the easier route
After that, I’ll tie everything down properly, add some loom, and clean it up—front side done
So anyone can tell what’s what and avoid plugging things in wrong, I’m changing the connector types
Keeping the wire colors consistent as much as possible makes things easier down the road.
With all these terminals, marking and tape labels really do get confusing~
More tomorrow? Hopefully
