Wow!
Thinking it through, cutting, grinding, welding—before you know it, the whole day is gone★
Today it’s aluminum, so AC welding★
I managed to get along with the material just a little bit today too…
I ended up going with a standard panel design…
Since I’m watching how it looks, the panel is still pretty large.
If it looks like I can trim it down, I’ll trim it more.
It’s insurance in case I end up welding it somewhere by accident.
Right now, only one side is fixed
Actually, it’s not flush with the surface—it’s recessed★
The meter looks a bit smaller, maybe?
Looks like the panel can wait until tomorrow!
If there was a place where I could sketch it out, fax it, have it laser-cut tomorrow, and have it delivered…
That would be amazing★
