3M Double-Sided Tape Ultra-Strong Heat-Resistant KHR-19R
Honestly, I’ve never even
looked for heat-resistant double-sided tape
But you know
when reusing a muffler emblem
it’s necessary
When I searched, there were expensive options and various others
Since I only needed a little bit
I picked this one up this time
ポチップ
The emblem is curled up
It’s tough to stick on the taper
And it’s thinner than I expected
super thin
Really flimsy (*´ω｀*)
I riveted it as is
but as expected, the edges lifted
I was looking for heat-resistant double-sided tape
that was reasonably thin
Found it!
For bikes, it’s pretty much fine with everything
The × part is…
Huh?
within common sense range, I think
Expectations just got too high
The manufacturer has it tough too
Just right at 1.5m
Perfect amount for trying it out
It’s a problem if you have leftovers you can’t use
Even if it’s pricey, small quantities are really helpful
0.8mm thickness
1mm is too thick, 0.5mm is too thin
Thicker material is more flexible but lifts
Thin material risks gaps
The balanced 0.8mm
is perfect (*´ω｀*)
Position it with rivets
Peel!
It’s not lifting!
OK! GOOGLE?
Finally got it secured (*´ω｀*)
By the way, I’ve removed it twice already, this is the third time
When you think about it, isn’t it versatile?
Because
Operating temperature range: -20~180℃right?
It’s fine even on a car dashboard
And on hot frames and tank backs
It’s perfect for those too…
If they had different widths and thicknesses, it’d be absolutely perfect
For anyone having emblem troubles, here you go!
ポチップ
