The mornings and evenings are getting a bit chilly. I’m having trouble deciding what to wear. Should I put away the heater?
The lathe replacement is complete, so we’re getting started on the work.
*Lathe machining isn’t quite ready yet, so it might be tough through next week.
The master tank is Brembo smoke (small), and they wanted it as low as possible, so we fabricated a new bracket.
The limiter cut didn’t have anywhere to go, so we made a bracket and turned it on.
I think this limiter isn’t that complicated, so it might be good to make a smaller one in the future.
We marked all the parts. Hopefully this will improve work efficiency a bit.
And so all the parts are clean and it’s complete.
A well-running bike has smooth idling and very smooth low-speed running without the engine building up momentum.
Definitely, subtle symptoms like low-speed “putter-putter” are best avoided.
On the right we made a mistake with a small ✕, so we remade it with a large ◎.
