So
They worked hard with a friend to install it,
but they were still worried and wanted me to take a look
When they installed a 65 mm AP, the center wouldn’t line up in the negative direction.
I’d like to grind it down—I want to remove 2 mm, but it’s thin at 9.5 mm.
This one is 9.3 mm.
Let’s go with this and call it good.
I’ll use mesh pads
and install them at 20 degrees on top and parallel, which keeps it simple.
The pad contact surface was off, so I ground it down and we’re done.
The old blog is here ★
