I’m getting threatened if I don’t finish this soon,
so it’s time to get serious.
Removing the needle bearings from the swing arm with the OEM special tool—already discontinued ★
I’m not really a fan of sliding hammers; a puller is definitely the way to go!
Cleaned up swing arm number two, replaced the bearings, and it’s looking good.
Measuring with super analog methods and installing.
Low pressure is really getting to me—I’m exhausted. I slept for about an hour and a half at the shop but I’m still tired
There’s still some oil residue, but it was rattling.
Extra grease
Packed in solid
