Everyday Events (Work Log)– category –

Let's install the ETC unit. Considering card insertion and removal, we settled on this position. Later, we added further reinforcement to make it box-shaped....

You don't see the Bandit 1200 very often these days anymore. We replaced the plug and air filter. We replaced the fluid. We moved it aside to replace the acc...

Continuing from before. It's pretty tangled up, but by maintaining a gentle radius and avoiding strain on the wiring, it ends up looking like this. I'd like ...

First, let's strip it down. Since we're not reusing switches and such, it's a bit easier. There are a lot of spots like this throughout. Electricity can easi...

Let's replace the main harness. It stopped partway through and came in on a flatbed. Let's track down the cause.             &n...

If vacuum cannot be obtained, we confirm synchronization with this gauge. The pedal has shielded bearings, so we just cleaned it and applied a light coat of ...

Bandit 1200 K6 Flat-Rate Motorcycle Inspection Deco-mainte NewTec Oil Change request. We remove the front and rear wheels and check them. It's good to clean ...

Let's perform Deco-mainte. I don't think it will run amazingly well, but by disassembling and checking it once, I believe we'll discover many things we would...

The Inazuma 1200 Katana is a great-running oil-cooled machine. #1 Gasoline was seeping from the joint, so we took on the job. The condition was good overall....

Let me check the front area. The axle came out, so that's good news for now. Unfortunately, it's bent… which means the fork is bent too… so we're putting thi...