So here’s the sequel,
but my motivation is flagging again and I’m getting sidetracked ★
I believe work starts with the right tools.
The hacksaw and coping saw from the other day got absolutely covered in foam, and it’s making a mess of my clothes and the shop…
When I search for “foam cutting,” I get articles about “cake sponge” and stuff like that ★
Reading through them, the advice is to “heat the knife and cut” so
boing! Will this work? With something like this…? It’s actually a pretty impressive tool that reaches 450 degrees in 10 seconds ★
Various interchangeable blades ★ Expectations are looking good!
Since I already cut the foam the other day, there’s nothing left to cut, so “I tried cutting just a little bit~”
The results are kind of so-so, so I might need to make some adjustments…
I might need to get a test piece and make a custom blade…
Not quite there yet.
