Oil’s leaking again.
Did I forget to tighten something?
You know how it is with this kind of work—you’re always second-guessing yourself.
Turned out to be something different, so that’s a relief.
Let me lay a towel on the ground and take a look… hmm…
That’s a pretty rare pattern.
I see… but why is it making contact?
Suzuki bikes from this era have the same cylinder pitch, so could it be from a different model?
Nah, that doesn’t make sense.
I spun a stainless steel wire brush hard and it came right out.
No wonder it was leaking.
Welding the oil pan.
Or rather, I’m nervous about welding cast iron that’s submerged in oil.
I’ve got nothing but bad vibes about it.
Clean it real good, degrease it real good. *Warming it in an oven or similar is effective.
A hole opened up, but that was expected.
Build it up, build it up.
I applied Devcon on the inside to seal it.
Now I need to avoid that contact point, but… I wonder if that’s even going to happen.
See you tomorrow!
