We don’t accept work on foreign motorcycles. Thank you for your understanding.
This was a center stand installation request…
I thought it would go on easily, but I was wrong!
There are almost no photos, I’m afraid (‘ω’)ノ
You need to remove the pipe shown in the image that connects below the left and right pivots.
Structurally, there’s no way to remove it without slightly spreading the frame while keeping it in place.
I suspect this is a part that was assembled before the engine was installed.
I’m not entirely sure what the anti-rotation pin is for…
I got it to fit without any cutting or modification.
In the end, it turned out the undertube had to come off too…( ；∀；)
I needed a 15 mm wrench and my spirits nearly broke a few times… Please be warned (*^-^*)
