I really love this color scheme the best.
I’m going to do my 750 like this too… and there are decals available…
Want to lower the handlebar by one notch → stock throttle cable interferes → swap out the throttle holder. That’s the flow (*^-^*)
I really love the TYPE-1 throttle holder.
Even with overall thickness, I’m a fan of solid M5 mounting…
TYPE-2 has very poor serviceability, so unless there’s a compelling reason…
All sorts of cheap-looking stuff is being sold out there… but if you can see from the outside that it works correctly, there’s no need to worry…
This standard shape just feels right.
There used to be a mag throttle holder at Craftsman back in the day… I wish they made it now…
The stopper bolt is ultra-low profile.
At expert level, they use PEEK bolts to be gentle on the sleeve too… or so I hear…
That’s attention to detail…
If you use an Active throttle, you can freely choose the spool diameter.
You can also measure the spool diameter you’re currently using with calipers and experiment with different options.
High-throttle equals heavy throttle, so please be aware.
The MCFAJ blood is stirring? So we’re lowering the handlebar by one notch…
The usual Posh Super Low Bar (steel). This time I went with black.
I was torn over the handlebar switch…
Yamaha? Honda? Kawasaki? I went through them in that order… and chose Kawasaki.
*Suzuki has recently been excluded from consideration…
Kawasaki 46091-1678
The reason for choosing it is the kill/start method and the length… less modification is always easier… *Though the time spent searching might be longer.
It was roughly 400 mm long. For those considering adapting it, here’s a reference.
The black sheathing at the base of the switch got instant-glued on… unbelievable.
I made sure to add a lock on the receiving end too.
The request is to make that mysterious? ETC antenna bracket look cool.
If I make the ETC bracket look cool… that should do it… so I made it out of titanium.
The rod is an anti-rotation device.
It mounts like this on the meter bracket side.
I positioned it as far inward as possible (^_-)-☆
It says don’t exceed 40 degrees… so I checked just to be sure…
By the way, my digital angle meter is made by Intercomp. (Bragging?)
The throttle cable length is now set, so I’ve placed the order~
For now, this is as far as the temporary assembly goes…
