Outer Duplex
Drag Cyclone
A world of enjoying non-existent Yoshimura products
It’s a combination, so there’s no extreme awesomeness
Hehe
Actually, it’s different.
As I always say
“Customization should be done at a custom shop”
We’re not a custom shop
I’ll temporarily fix it and think about it.
Front or back or… raising or lowering
This is a world of preference and subjectivity
It’s better not to leave it to someone with different preferences
I think.
The most free time
No matter what
If you can’t physically layout
You need to be careful.
I’ll cut it with a metal saw
Lately, even high-speed cutting machines
seem to have chip saws
If it cuts cleanly
That works too
Metal saws are essential though~
I’ll expand the pipe with an expander
I’ll expand it to fit the insertion of the collector section.
Since it’s a split type, if you shift the position while expanding
You can do it nicely.
It’s really about the tools
That’s when I think.
The benefit of saving time and doing it cleanly
is very significant.
For now
hand pulse.
I still can’t get the positioner set out
…
I don’t have many opportunities to do muffler work
either.
With just the collector side and one angle piece
I managed to make it work.
Since it’s mine, I’ll go aggressive.
I’ll make a bracket…
But it’s getting a bit tedious.
Mine isn’t good~
I’ll reuse the remains from the removed Yoshimura
Basically not a very good mounting
As much as possible
If you can support it with a wider surface
It’s less likely to break and repairs are easier too
All done!
The stock muffler is also a megaphone
While adding an original feel
It’s complete (*´ω｀*)
Just the right balance ♪
Since I’m an old guy, I’m not good at aggressive angles
I prefer the tail line plus a bit.
Since it’s JMCA
Safe sound level!
Hmm, mild ♪
It’s good in a peaceful world
I’ll remove the plate
and repaint it.
Didn’t take 2 hours…
Since it’s mine
I can go at it hard, which is a point
But still
Mine is the most fun.
After it’s done, I look at it
and “savor the afterglow”
That’s another pleasure (*´ω｀*)
