Well, let me continue with the remaining work from yesterday (*´з`)
This time I went a bit against the grain and “70 degrees” to give it a try.
I’m tired of seeing the hose drooping “all floppy” toward the rear… that’s the feeling.
The upper side uses my favorite “short straight banjo”
As far as I know, “Garuda” or “Rears”
are the only places you can get them.
It has a nice retro vibe to it.
I fabricated the master tank bracket.
I tried to keep the design as close as possible to the left and right.
I cleaned three calipers (*´з`)
The rear pads were completely worn, so I replaced them.
The reservoir hose is tankless and at a very bad angle,
so bleeding the air took quite a bit of time.
After that, a test ride and it’s complete.
