Two bikes in the same color. If we work on them at the same time, we might mix them up~
Please proceed with whichever one finishes first.
And just like that, it’s done. The surface is smooth mesh, so I don’t think it will fray or break from rubbing.
Nothing fancy, but I fabricated a bracket to secure the TEE-FIT.
And that’s how it’s finished. As low as possible and symmetrical left and right~
The combination of K Factory large-diameter piston and 19φ master works great.
The seal is an O-ring rather than a cup. I recommend removing it once, applying metal rubber, stroking it a bit by hand, and then reassembling.
When it’s black, nobody can tell.
The stock clamp looked ugly, so I secured it with Heraman and ultra-low-profile fasteners.
