Continuing on. The starter valve and the tube on the air cleaner side are in the middle of the overhaul—
There’s only one fuel outlet, so I’ll plug it with tape and check the fuel level.
To be honest, on models where the float arm sticks out from the body, the float level is usually fine. The Mikuni BST is a bit of a different story.
Cutting it is a pain, so I’ll drop it with a die and then finish it.
I welded a nut on the back.
I made a simple case.
Fixed it in place.
How does this look?
One dial is missing.
So we’re holding off for now.
