Let’s continue with the maintenance.
A Brembo-style chrome caliper is installed. It appears to be functioning without issues at the moment, but considering safety, I think it would be prudent to keep replacement in mind for the future.
A wave disk of unknown manufacturer. This is concerning too.
The bearing was driven in too far, so I adjusted it.
The manual specifies lubrication, but I don’t think it’s particularly necessary. Additional grease is even less needed.
Let me check it just to be sure. Glad there are no issues.
The front wheel had runout.
This bike is quite dirty, but we can’t make progress unless we clean it up to some extent now.
The wheel bearing is still okay. Just keep it in mind for now.
The dust seal contained quite a bit of debris. The operation seems fine for now.
I’ll replace the pad pins.
Use the pads until they reach their limit, then replace them together with the disk.
