I’ll remove the fabricated parts temporarily for painting (*^-^*)
Continuing with the work.
I’ve fabricated a rear brake hose.
As always, it’s a subtle, understated design.
Like a snake crawling, you know?
I wanted a high-mount exhaust for the front too, but… I thought about it overnight and will reconsider it carefully.
When attached to the open hole, it angles inward.
The cowl side has an angle and a gentle curve. When attached, it ends up angled inward, so I’m rejecting it.
The front of the cowl is hardly cool either, so I’ll go with embedding and reusing it.
The original is correct with two poles.
This one is five poles…
It’s 3XV-82501-00, not 3MA-82501-00 ( ；∀；)
Too bad…
