
On older Z-series and GS/GSX bikes, the connector and bullet terminals between the regulator and generator burning out is pretty common, right?
With this Ohm Electric OA-QTM34 screw-mount multi-position insulated terminal cap, screw-mounting it pretty much eliminates that burning problem *compared to our standard.
You can easily get it from places like Monotaro.

The product is very compact, but it does have some width, so lay it out carefully.

The size and dimensions are shown in the diagram above.
It’s nice that there’s an M4 mounting boss too.

Press the left and right tabs inward and slide to open it easily.
Mount two terminals each at three locations total and you’re all set.

The mounting screws are M4.

A dedicated cover is also available. A cover is also available.
QTM-34C It’s a bit tough to find individual units for sale.

Here’s what it looks like when installed.
Since the overall length gets longer, you can cut it down if you like.

The ring terminal sizes you’ll use. *Space width measured at 8.64 mm
For 1.25, R1.25-4
For 2.0, R2-4S (S = small)
