
On older Z-series and GS/GSX bikes, the regulator and generator connector or spade terminals burning out is pretty common, right?
With this Ohm Electric OA-QTM34 screw-mount multi-pin insulating cap, tightening it down nearly eliminates that burning symptom — *compared to our baseline.
You can easily get it from Monotaro and similar suppliers.

The product is very compact, but it does have some width, so lay it out carefully.

The size and dimensions are shown in the diagram above.
It has an M4 mounting boss too, which is handy.

Press the left and right tabs inward and slide to open it easily.
Secure two wires each at three locations total and you’re done — perfect.

The mounting screws are M4.

A matching cover is also available. A cover is also sold separately.
QTM-34C Individual units are hard to find, which is a bit of a drawback.

Here’s what it looks like when installed.
Since the overall length is long, you can cut it to fit if you like.

The ring terminal size you use. *Measured space width is 8.64 mm
For 1.25, use R1.25-4
For 2.0, use R2-4S (S = small)
