Well then… the connectors have arrived, so I’m going to start routing them.
I think if I fix the USB too rigidly, it won’t have any flexibility… so I’m going to go with a clip-on dual lock.
It can be turned on whether mounted vertically or horizontally.
Of course, it can also be relocated to other locations.
I extended the wiring and connected it to the D-UNIT.
The USB output is working fine too.
I was planning to finish by putting the cowl back on…
Huh? Is there a crack in it?
Fiddling around… and it broke off (；∀；) Oh no~
I quickly applied Megmix, but it’ll probably break again… so I’ll reinforce it lightly.
0.8 punching to Megmix and crimp.
This should be fine. Next time it might break over a considerable area? Maybe. *Just kidding – it should be okay.
After that, I’ll let it dry until tomorrow, polish it lightly, and it’ll be done!
