Kamedakari Hydraulic Puncher Mod (*’ω’*)
Compared to using a hydraulic press
• Flexible with space
• Face-to-face alignment makes it possible to press nearly straight
Hydraulic presses are pretty wobbly, andthe surface isn’t really flat, I think…
What do you think?
When you ask what I mean by surface… it’s level with the ground… well, the Earth is round, right?
When removing, use a puller and set press together.
Temperature difference and hydraulic power are amazing…
I often feel the weakness of manpower…
Using a dedicated attachment to heat and press it off pop… there’s no technique or trick to it.
The hydraulic press doesn’t really have a flat surface?
As you can seeeverything is made loosely.
If it weren’tthe upper and lower bed movement wouldn’t work. It does come out pretty decent though.
Actually, if you press-fit with hydraulicsit goes in even if it’s pretty crooked.
Huh? That’s bad?The moment you think thatit screeches and scratchesso you can’t proceed loosely, right?
The puncher can be pressed in with face-to-face alignment, so GOOD♬
Press-fitting is extremely easy.
Positioning comes out so easilyquick-quick♬that’s how it is.
Even in tight spots likethe swingarm shown in the imageyou can press-fit with ease.
With a hydraulic press it would be quitetricky positioning that you couldn’t show customers, you know?
You have to make various attachments on the lathe
That’s the tedious part.
Press-fitting work is alreadyall about the attachmentsand you have to make new ones as needed, but you have to add this on top of it.
Convenient, right? Even as I write thisit’s a bit niche, so for people who can take on the challengeI think it’s good.
Steering race press-fitting is also a breeze, so if you’re looking for reliable, fail-proof press-fitting, I recommend it~
