The relationship between the lift and lathe position is terrible…
I can no longer shoot from directly to the side (；∀；)
First, I’ll get started on the brake calipers!!!!!
I’ll skip over the exterior (‘ω’)ノ
The rear has already been cleaned up partway by the owner.
The condition of the front calipers is pretty good considering the year.
* I wonder if my sense of what’s “good” has gotten a little off lately…
The brake pads have absorbed oil quite thoroughly, so they’ll need to be replaced.
The pistons are in good condition overall, though two of them have some light rust.
I’d like to reuse these and move forward.
First, I did a full wet-blast treatment on everything~ (ΦωΦ)
