デコボコ– Author –

Incredible craftsmanship. A chain-pulling caliper support—what a surprise. I wonder if it's an issue with the sprocket we purchased. Our milling machine is a...

The fresh green is dazzling. Apologies for the simplistic design. Since removing the seat is a hassle, please access it from the side cover instead. The ante...

A beautiful Z1000R-2. We'll work on it step by step. The owner was concerned about leaks, but there don't seem to be any particular issues. This might be wha...

Let's install the ETC unit. Considering card insertion and removal, we settled on this position. Later, we added further reinforcement to make it box-shaped....

You don't see the Bandit 1200 very often these days anymore. We replaced the plug and air filter. We replaced the fluid. We moved it aside to replace the acc...

Continuing from before. It's pretty tangled up, but by maintaining a gentle radius and avoiding strain on the wiring, it ends up looking like this. I'd like ...

First, let's strip it down. Since we're not reusing switches and such, it's a bit easier. There are a lot of spots like this throughout. Electricity can easi...

Let's replace the main harness. It stopped partway through and came in on a flatbed. Let's track down the cause.             &n...

If vacuum cannot be obtained, we confirm synchronization with this gauge. The pedal has shielded bearings, so we just cleaned it and applied a light coat of ...

Bandit 1200 K6 Flat-Rate Motorcycle Inspection Deco-mainte NewTec Oil Change request. We remove the front and rear wheels and check them. It's good to clean ...