Everyday Events (Work Log)– category –

Deco-mainte continues. We'll replace the spark plugs. The fluid is quite cloudy. This might be a good time to change it. The carburettor synchronization on t...

Inspection and Deco-mainte The levers, pedals, wires, and throttle still had plenty of lubrication on them. However, as time passes, the old lubricant does g...

Inspection and mini maintenance.   The fluid was showing some signs of wear. Carburettor synchronization needed only minor adjustment. All good. I clean...

Let's switch from clip-on bars to bar handles. Antlion is frequently used because the shaping, low position, and forward reach feel great. I'd like to drill ...

D.I.D ZVM-X&Sunstar service kit + The counter shaft deserves careful handling. While it's a problem if it falls off during riding, it's also inconvenient...

Inazuma 1200 Katana. Let's perform oil-cooled maintenance. The generator damper had become rock hard. The engine damper was also quite worn and very loose. T...

Let's install the carburettor. The tank rust doesn't look like it will be a problem. Whether it's the material quality or the coating or something else, it d...

GS1200SS-2 carburettor maintenance, etc. Years of grime built up quite a bit… Today I'll just wash it, take it apart, and get it prepped. Buzz buzz buzz! Mak...

Oil-cooled maintenance request. The engine damper shows considerable wear. The generator damper had hardened like plastic too. We found oil seepage, so we ch...

It hadn't been ridden much at all, but it started leaking anyway. Let's just replace the seal. You can remove the oil seal from the top without taking out th...