2023-01– tag –
-
Before stripping Phillips screws on the carburetor – use a Makita impact driver for more reliable results
Phillips screws are especially prone to stripping, so caution is necessary. Removing a bolt is quick if it comes out easily, but if it gets stripped and won'... -
Z1R EDR-21α Drive Recorder & D-UNIT+ Installation Oil Change
When I try to install it the way I envision it, "more custom parts are needed." Is it enough if it's just installed and functioning? I need to think carefull... -
Cordless soldering iron and heat gun are so convenient they’re practically unbeatable.
I used them at work right away. I really recommend going cordless with power tools. First, work gets faster, and taking them out and putting them away saves ... -
Z1R EDR-21α Drive Recorder & D-UNIT+ Installation Oil Change
According to my schedule... I should have completed this today and sent the invoice by email... Why is this taking so long? Probably because I was tidying up... -
Episode 47 [Inazuma 1200] Air-Fuel Ratio Meter “Abnormal Reading”. Cause: “A/F Sensor LSU4.9”
Well, about the A/F abnormal reading from the other day... it turned out to be a faulty A/F sensor. By the way, it hasn't even been used for 2000 km and it's... -
Electronic vehicle inspection certificate starting today. Currently “no sense of excitement” but hopeful for the future?
I got the inspection done on my Inazuma 1200, cutting two months short. I'm not happy about March being the month anyway. . . . September through November is... -
Shuto Expressway Soft Touring “Sangenjaya~” ¥1,340 (C2→B→1→K7→Daisan Keihin) Full Loop
The Shuto Expressway is heaven when it's empty? (*´з`) We'll continue with cam break-in and investigate the mystery of the mysterious lean ban(?).Please igno... -
Better late than never: Netflix in 2023. I’m amazed by the addictiveness of foreign dramas
I finally made my Netflix debut, better late than never. Back in the day, there were shows like 24 and Prison Break—I bet your generation watched them too, r... -
2023! Five Makita picks we’re a bit curious about
So we basically wrapped up Makita in 2022, or so we planned (*'ω'*) Just one item left on the list (;'∀')I've looked through the Makita general catalog over ...
