NUTEC– tag –

Let's move on to the remaining work. Today is the remaining Deco-mainte work including the rear. The chain slider is a really satisfying spot to work on—just...

I thought it over from various angles and decided to make the heel guard bigger. I want to stand the ribs up, but there are few places where I can secure it,...

The cord was inserted into the coil. It's a slightly unusual layout, but the serviceability should be better. The cap is oriented toward the coil side. It's ...

This one has the same work scope. I don't forget the work itself, but I get stuck on which photos to use when updating the blog… Believe it or not… the list ...

I'll skip some of the carburettor maintenance details. Now that the fuel level adjustment is complete, I'll reassemble it. I'll replace the rubber parts whil...

Let's install the Uotani SP2. The included bracket makes removal difficult. We don't take it off often, but it gets in the way surprisingly when we remove th...

We didn't forget the work. The sub-harness just never arrived from the supplier. We peeled away what we could and then wiped it clean. There's quite a bit of...

If I update halfway through, I have to read back to see how far I've gotten. It's no good if I skip even once. This isn't a recent part. I'll re-oil the wire...

For now, I'd like to progress as far as I can. Since we're removing the wheels, let's clean the chain slider and the area under the case while we're at it. I...

It had been sitting for a little over two years. Motorcycles really do deteriorate quickly when they're not being ridden. First up: carburettor disassembly a...