Wheel Bearing Maintenance– tag –

We removed the carburetor to replace the harness, so we gave it a light cleaning. While we're at it, we'll replace the throttle cable too. Cleaning and lubri...

Let's inspect the starter clutch. The assembly is already discontinued… It's a male-threaded type, and we don't have the puller in stock. We'll arrange one s...

GSX1100S main harness replacement, wheel bearing maintenance, Deco-mainte, NewTec oil change and more on request. For an air-cooled four-cylinder, thirty min...

Let's perform rear maintenance (+) OH. It's rare to see a bike rusted this badly. I was quite surprised. Here are the parts we're replacing. It feels good to...

The wheels really stand out once the lower end is cleaned up. We prepare to ship to Nishimura Coating. We need to remove parts and clean them as much as poss...

Let's perform oil-cooled maintenance. The shift seal was leaking, so I replaced it and sealed it with NC100 for moisture retention. The engine damper showed ...

Let's replace the wheel bearings. These are single-sided seals. When replacing them, we convert both sides to non-contact seals. Double-sided seals better co...

The GS1200SS cafe racer has become quite popular lately. We also relocated the ETC unit. Since it's bent and then bored, it remains strong even when quite th...

This is the GS1200SS from the other day. It's the usual small-part fabrication. I think about how to keep things simple and efficient, and how to connect it ...

This is a request for a GS1200SS in red and black with a Flat-Rate Motorcycle Inspection, wheel paint, wheel bearing maintenance, and more. The paint work is...