Well, the parts finally arrived in the afternoon
After confirming the float level, it’s best to check the actual fuel level if possible.
I lightly polished the float valve and reused it.
The float level is usually fine,
but occasionally something doesn’t match. (One spot this time too.)
Does it overflow when gasoline flows through?
Is the fuel level gradually rising? That’s what I’m checking.
Balanced it out
Perfect!
Before getting here, I was told a Dynojet was already installed.
Let me check what type it is. There’s no marking on the needle, so I’m guessing from the main jet…
The parts list shows two different specifications.
The manual shows almost just one? Hmm?
Anyway, once I know the carburettor is working properly, I can adjust the jets,
so I made a few small tweaks with what I had on hand.
It’s pretty good for something improvised.
