Electrical system– tag –

We performed additional work: Brembo radial master cylinder and brake hose fabrication. The TEE-FIT is indeed bolted down nicely and looks clean. First, we c...

Getting a bit off track here. The headlight lens was cloudy, so I cleaned it up. Just a gentle rinse and it comes out this clean. I replaced the front and re...

Removing the cover is quite a challenge. This first job is full of mysteries. It wouldn't budge at all, so what's going on? There's a bearing on the cover si...

The bearings arrived, so let's swap them in. It's a simple one made from scrap material, but once you build it, you can use it again in the future. Of course...

I thought it over from various angles and decided to make the heel guard bigger. I want to stand the ribs up, but there are few places where I can secure it,...

The cord was inserted into the coil. It's a slightly unusual layout, but the serviceability should be better. The cap is oriented toward the coil side. It's ...

Let's install the Uotani SP2. The included bracket makes removal difficult. We don't take it off often, but it gets in the way surprisingly when we remove th...

We didn't forget the work. The sub-harness just never arrived from the supplier. We peeled away what we could and then wiped it clean. There's quite a bit of...

As an additional job, let's install the Uotani SP2 unit cleanly. The mounting location is tight, but it's suddenly complete. I forgot to take a photo, but fr...

Delivery came faster than expected. We're really grateful for that. The inspection is already done, so let's get to work. It's a real "THE ETC!" kind of inst...