Front Maintenance– tag –

We were asked to perform oil-cooled maintenance as an additional service. Before removing the generator, you need to remove the sprocket cover. Even if you m...

Let's continue with the work. We visually confirm that everything is properly seated. We shouldn't harbor doubts like whether the coaxial alignment is correc...

Front maintenance (stem+) request. (This time there will be no fork oil change.) I checked inventory and found an upper seal in stock. Since no one else seem...

We'll continue with the work. Just a little more until completion. We'll adjust the synchronization. The deviation is slight, so no worries. If you ride it, ...

We'll continue with the work. The grease around the levers is pretty much gone. I've also disassembled, cleaned, and lubricated the throttle. I'll replace an...

Let's continue with the maintenance. A Brembo-style chrome caliper is installed. It appears to be functioning without issues at the moment, but considering s...

We can't just hand over the oil cooler as is. I'm torn between whether it's easier to repair the cooler or to fabricate a bracket. Roughly, this is the cente...

I think everyone prefers a clean finish if possible. Hmm. There's Devcon here too... I removed it but found nothing underneath. It was just sealing it. Both ...

This is a GSXR1100. It's got quite a sharp specification to it. Overall it looks pretty whitish. It's in a very dirty condition. Lifting the front up... on t...

46 mm upright fork. You should know the inner tube outer diameter, metal outer diameter, and bottom case inner dimensions. Despite not having been serviced i...