It’s always out of my own pocket. . . . .
The Kijima grip heater GH-10 is what I could choose and consider right now, and I think it has the best balance overall. That’s the feeling I had when I bought it.
Before the cold season that’s looming right ahead arrives, please use this as a reference~
It was supposed to arrive yesterday, but . . . . grumble grumble (*´з`)
Well, never mind. The GH10 L = 120 mm model. There’s also one that says L = 130 mm, so it’s good to choose one that matches your bike.
The design is aggressive? Calling a grip aggressive doesn’t really make sense, but . . .
I think it’s better than bulky.
I was honestly making fun of grip heaters. . . me.
I was in the camp that said you don’t need them if you’re wearing pair throttle gloves. But then a turning point came.
When I bought a CB1100 SC65 before, it came with a grip heater.
( ´ー｀)Phew. . . ~ I don’t need that! I thought, but when I actually tried it . . .
“This is . . . wonderful♪”
Even with thin gloves, I can ride in the cold season = I’ve reached a point where I can’t go back to thick gloves.
And before winter comes, I want to put a grip heater on my Inazuma 1200! I’ve been agonizing over it these past few days, and that’s when this GH10 caught my eye.
The grip feel is quite hard.
I like hard grips, so it’s a ◎ for me, but for those who are sensitive to vibration, maybe?
To make the diameter thinner, some compromise is probably unavoidable.
Actually it’s under 32φ!
Since I’m the type who likes thin, hard grips, it’s very good for me.
The length is no different from a standard grip. You can install it with confidence.
The module is excellent.
Thin, compact, and with a built-in mini fuse! It’s really well thought out . . . .
Perfect.
Three winding adapters included.
It’s compatible with the stock throttle holder.
The rear position can also be adjusted freely, so there’s no issue with the grip heater wiring being annoying.
Isn’t this a well-thought-out system?
If everything can be installed, you can change the winding diameter (a back-door trick)
34-37φ so you can play around a little bit in spirit.
You could even shave the throttle cable pull side a bit to make it variable, which might be fun (at your own risk)
The manual has no information about part numbers or small parts . . . why.
KIJIMA Kijima 【Replacement part】 Grip heater GH10 Grip
KIJIMA Kijima 【Replacement part】 Grip heater GH10 Throttle adapter set
Probably if you contact Kijima, you can get them individually, right? Or maybe not . . .
If possible . . . or rather, if it’s feasible . . .
Getting it from D-UNIT without regret is really good.
That’s right. You just plug it in. *If you make it 110-series connector compatible, it’s the best♪
The response is also very good. Since it’s currently a temporary connection, I’ll shoot a product introduction video once I’m ready~
Get it while you can choose! It might give you peace of mind.
