Everyday Events (Work Log)– category –

Let's install the Uotani SP2. The included bracket makes removal difficult. We don't take it off often, but it gets in the way surprisingly when we remove th...

We didn't forget the work. The sub-harness just never arrived from the supplier. We peeled away what we could and then wiped it clean. There's quite a bit of...

If I update halfway through, I have to read back to see how far I've gotten. It's no good if I skip even once. This isn't a recent part. I'll re-oil the wire...

For now, I'd like to progress as far as I can. Since we're removing the wheels, let's clean the chain slider and the area under the case while we're at it. I...

It had been sitting for a little over two years. Motorcycles really do deteriorate quickly when they're not being ridden. First up: carburettor disassembly a...

If you leave it sitting, it gets bad fast. This one's pretty rough. All the jets are shot, and the needle valve is completely gone too. The needle won't come...

We decided to do the Self-Point Maintenance 30 on this one too. Since it's the same bike as before, we know our way around it. Let's clean up the levers and ...

Quite a few Unicorn Inazuma 1200 Katanas have been sold, haven't they? It's getting hard to tell which one belongs to whom… Let's clean the chain. It's one o...

The rear suspension isn't returning, so it's stretched out nicely. The Inazuma 1200 has been added to the Uotani SP2 lineup. Let's get it installed. We remov...

We're moving into the final finishing touches. The last part always takes the most time. License plate light cover. Since it's a plastic part, there's a comp...