Everyday Events (Work Log)– category –

GSX1400 Yoshimura Digital Temperature Meter Installation This is the work to permanently mount the digital temperature meter that was temporarily installed a...

BIMOTA SB3 Newtech Oil Change – Brake Pads & Fluid Replacement The fairing and muffler need to come off, so this takes some time. Work carefully to avoid scr...

SUNSTAR disc and SSITO carrier support installation. The SUNSTAR disc has the cotter pins reversed from the original, sitting flat. The distance from the sup...

Let's install the AS Uotani. Mounting the unit directly with double-sided tape is honestly questionable. When you remove it, the adhesive stays on the bike b...

Various requests to go along with the inspection. We fabricated the bracket in stainless steel, so now we move on to drilling holes. There's a lot of cutting...

Let's refresh the small parts. We'll also fabricate a new brake master cylinder tank bracket. Excellent clarity—H2 spec The lever and holder didn't match, so...

We received a request for GSX1100S harness replacement and electrical system installation. We're also upgrading to a PAMS MOSFET regulator. Since there was a...

PAMS High-Performance Fuse System · MOSFET Regulator· New Tech Oil Change request. The MOSFET regulator has a large surface area and generates little heat, m...

GSX1100S inspection and Deco-mainte service request. The throttle area was well maintained and looked clean. Both levers feel good. Rather than applying oil ...

Let's disassemble the front fork. There's a little dirt, but it's in relatively good condition. It's fortunate that this fork doesn't require cylinder disass...