GSF– tag –

Let's take measurements when installing the Okada Projects unit. Since it's noisy at night, we do the measurement check in the morning. We measure every time...

Let's install Okada Projects Plasma Booster and V Plus. We're still exploring the best mounting method—nothing has been finalized yet. We basically don't do ...

Running a bit behind schedule. Almost there though~ Sunstar offers a hard black option for aftermarket wheels. There's a rear option too, so we went with 525...

We received a request for Okada Projects Plasma Booster and Sunstar rear brake disc replacement.     This is the popular Okada Projects Plasma Boos...

Let's install a popular T-REV. We bend it with a bender—no sand filling or heating needed, it just bends smoothly. SUS304 T=1.00 OD12.7 We create a retaining...

Fastener installation that was left halfway through. Or rather, cowl installation. Last time we stopped after installing the upper section. ↑   We bent ...

It's progressing gradually. Machining from a solid rod is a pain. But I don't have any thick-walled pipe like this on hand… I'll use OEM parts packed togethe...

The shaft is BITOR&D at 25φ. Double-sided cutting, huh… It wasn't as easy as I thought… I wonder if I can actually make it. Since I don't have much mater...

Cam cam glug glug. Let's do the oil-cooled maintenance. The damper was wearing down at a good pace. Cleaned it out thoroughly Swapped it for a later-model da...

Jumping around here and there, I'm not sure how far we've gotten with the updates...   We applied Cerakote to the bottom case. Since it's an ultra-thin ...