Vehicle Inspection– tag –

Let's take care of a little extra while we're at it, beyond what was requested. To prevent rust, coolant should be changed at least once every two years. The...

Initially we were planning just a fork oil change, but we decided to go ahead with an OH since there was a slight seep. I'm the type who likes to push forwar...

Since it's large, let's leave it with us for a full day. Engine oil in two places and gear oil. The gear oil is clean. The oil level hole in the center was a...

The connecting plate arrived, so let's install it. Three out of four pieces had cracks. Since it's in the choke passage, it shouldn't cause any problems, but...

Let's perform a valve clearance adjustment. To be honest, I don't think valve noise gets too bad very often. What does happen is the cam can seize, the rocke...

Today we're going to do some oil-cooled maintenance. Recently, starter motor O-ring replacement has been included as part of the package too. It's great to b...

Does a vacuum carburetor look shabby because of corrosion and deterioration? I'm not fussy about maintenance cycles—the stock carburetor is wonderful because...

The inspection is complete. I'm going to keep the maintenance light. I'll wipe down the chain thoroughly, then oil and adjust it. Both left and right levers ...

The inspection was completed this morning, so let's keep moving forward. No progress shots. It's the N switch and starter motor O-ring. Steering had a bit of...

With a 180/60 tire, it got wider and the chain started hitting. Let's check how much clearance we can get. Well, before that I checked it by hand. The counte...