デコボコ– Author –

The bottom case machining is complete, so let's assemble the fork. When we disassembled it, the condition was extremely poor. At first I thought maybe it had...

Let's replace the wheel bearings and so on. There isn't much wear, but occasionally we find oddly modified parts, so this is an area we need to pay close att...

This GSF1200 shows signs of wear throughout. Let's inspect each component and clean it up. The steering stem shows no signs of previous disassembly, but it's...

GSX1400 Yoshimura Digital Temperature Meter Installation This is the work to permanently mount the digital temperature meter that was temporarily installed a...

BIMOTA SB3 NUTEC Oil Change – Brake Pads & Fluid Replacement The fairing and exhaust need to come off, so this takes some time. Work carefully to avoid scrat...

SUNSTAR disc and SSITO carrier support installation. The SUNSTAR disc has the cotter pins reversed from the original, sitting flat. The distance from the sup...

Let's install the AS Uotani. Mounting the unit directly with double-sided tape is honestly questionable. When you remove it, the adhesive stays on the bike b...

Various requests to go along with the inspection. We fabricated the bracket in stainless steel, so now we move on to drilling holes. There's a lot of cutting...

Let's refresh the small parts. We'll also fabricate a new brake master cylinder tank bracket. Excellent clarity—H2 spec The lever and holder didn't match, so...

We received a request for GSX1100S harness replacement and electrical system installation. We're also upgrading to a PAMS MOSFET regulator. Since there was a...