デコボコ– Author –

Let's install the NCR oil cooler. It's been a while since I've worked on my own GS1000S. This is the NCR oil cooler that finally arrived after summer. Its sc...

GS1200SS-II Inspection/Self-Point Maintenance/NUTEC Oil Change The oil had dried off the lever, so this might be good timing for maintenance. The throttle wa...

Let's swap out the meter. We embedded a PIVOT. The speedometer has a slightly different shape. In the end, we ground down the bracket to make room. It won't ...

Meter replacement/relocation, handlebar replacement, lens replacement, and direct battery relay installation. We use a Daytona relay. You can make one yourse...

Continuing on. NGC Exhaust Lineup Hand-bent pipes look great on air-cooled bikes and give a nice impression. Steel has an image of being heavy, but since thi...

Let's install the NGC exhaust. NGC JAPAN A beautiful exhaust with elegant hand-bent curves. Installation is extremely smooth—you can temporarily fix cylinder...

Deco-mainte continues. We'll replace the spark plugs. The fluid is quite cloudy. This might be a good time to change it. The carburettor synchronization on t...

Inspection and Deco-mainte The levers, pedals, wires, and throttle still had plenty of lubrication on them. However, as time passes, the old lubricant does g...

Inspection and mini maintenance.   The fluid was showing some signs of wear. Carburettor synchronization needed only minor adjustment. All good. I clean...

Let's switch from clip-on bars to bar handles. Antlion is frequently used because the shaping, low position, and forward reach feel great. I'd like to drill ...