Everyday Events (Work Log)– category –

Cast iron really does clean up nicely when you polish it. Cleaning three calipers. Lately I've been using hot steam to blast them clean. They come out spotle...

CBR1100XX Deco-mainte request. First, the lever area—you can clean it from the outside just fine, but removing it lets you get deep inside for a thorough cle...

We had a request for self-point maintenance and dashcam installation. There's a budget limit. As we got into it, it turned out to be more work than expected—...

We bundled together the electrical system work. A classic setup with grab handles and binder cord securing. We also fabricated a relief, grew guides and stud...

Silencer alignment and bracket direct mounting and more~ We welded the ON bracket to the existing bracket. If we were to remove the existing one and repositi...

Rear maintenance plus OH as the main job with some additional requests on the side.   First up—we're returning the handlebar to standard. We considered ...

Today we'll do a fork OH. It's a relief that there are so few parts to work with. We check for bending, and lightly polish the inner tubes. We clean up the b...

I'm reflecting on how I almost delivered the bike without remembering most of the work I was supposed to do. Let's proceed step by step. PAMS MOSFET/turn sig...

It finally arrived! Let's install the Yoshimura engine cover. I'm getting ahead of myself from the 1100. The other day something strange happened. A customer...

Now that I have all the materials, I'll continue with the work.   The angle was too tight and it got stretched out and squeezed. At 45 degrees it should...