GV73A– tag –

Okada Projects Plasma Booster on order. The trick is how to install it smartly where it won't be seen... If only we could just stick it on with the included ...

All right, let's keep moving forward. We've been asked to fabricate a cowl vibration damper. There's nowhere to get a boss from at all… Connecting the left a...

The connecting plate arrived, so let's install it. Three out of four pieces had cracks. Since it's in the choke passage, it shouldn't cause any problems, but...

Let's perform a valve clearance adjustment. To be honest, I don't think valve noise gets too bad very often. What does happen is the cam can seize, the rocke...

Today we're going to do some oil-cooled maintenance. Recently, starter motor O-ring replacement has been included as part of the package too. It's great to b...

We used what we could and made it look the part. Let's change the fluid. Ideally once a year, or at minimum every two years is better. I made a bracket for t...

Let's do some self-service point maintenance. The aluminum fittings look like this, so you need to be careful. Amazingly, it doesn't leak—I'm impressed. Firs...

Let's perform front maintenance. This time we're replacing the inner tubes. It's a phenomenon unique to inverted forks where they always wear down at the sam...

Does a vacuum carburetor look shabby because of corrosion and deterioration? I'm not fussy about maintenance cycles—the stock carburetor is wonderful because...

The hub arrived. We ran out of drive sprocket lock washers in stock, so we got partway through— When you heat it in the oven, it expands in this mysterious w...