デコボコ– Author –

Tomorrow is a lucky day... I stripped it for welding... I hope it turns out as a hairline finish. I'm really short on content and time these days. In a corne...

Silencer alignment and bracket direct mounting and more~ We welded the ON bracket to the existing bracket. If we were to remove the existing one and repositi...

Rear maintenance plus OH as the main job with some additional requests on the side.   First up—we're returning the handlebar to standard. We considered ...

Already a lucky day again? With year-end approaching, I can't get my hands on much. I apologize for the super light content. Old bikes have big turn signals,...

Today we'll do a fork OH. It's a relief that there are so few parts to work with. We check for bending, and lightly polish the inner tubes. We clean up the b...

I'm reflecting on how I almost delivered the bike without remembering most of the work I was supposed to do. Let's proceed step by step. PAMS MOSFET/turn sig...

Progress is slow and steady, one step at a time, though momentum is hard to build. The content is always a bit thin. 5052/T=5MM—chosen so it can be welded la...

It finally arrived! Let's install the Yoshimura engine cover. I'm getting ahead of myself from the 1100. The other day something strange happened. A customer...

Now that I have all the materials, I'll continue with the work.   The angle was too tight and it got stretched out and squeezed. At 45 degrees it should...

Tomorrow is a lucky day. It's the dusty cutting work I really dislike. Due to time constraints, I'll just do the left and right plates and the brake pedal bo...